masssetr.blogg.se - Photo reflector bars

Photo reflector bars manual#
Photo reflector bars registration#

Photo reflector bars manual#

See section 28 (rear fog lamps) of the IVA inspection manual for full inspection standard.

‘B’ or ‘F’ mark signifies it is a fog lampħ.3 The standard rear fog lamps must meet.

‘e’ or ‘E’ mark means that the lamp is approved and is acceptable in the United Kingdom.

display an ‘e’ or ‘E’ mark with a ‘B’ or ‘F’ (see manual for exemptions).

only illuminate when dip, main or front fog lamps are lit.

have insulated wiring, that is secure and fitted through a grommet (where applicable).

Where 2 rear fog lamps have been fitted they must be a matched pair and mounted symmetrically.

within the EU the light will probably be just on the nearside so will need to fit an additional one to the offside.

outside the EU it is likely that it won’t have a rear fog lamp fitted so you will need to fit a rear fog lamp or lamps.

Section 20 of the IVA inspection manual covers lamp installation and must be read in conjunction with sections 21 through to 30.ħ.2 What to check before rear fog lamps are inspected Installation of lamps 5.1 How installation of lamps are inspectedĪll obligatory and optional lamps fitted will be checked. See section 22 (side lamps) of the IVA inspection manual for the full inspection standard. To make sure you meet the requirements refer to the table in section 20 (installation of lamps) of the IVA inspection manual. There are a minimum and maximum number of lamps that can be fitted.

Photo reflector bars registration#

4.2 What to check for before side lamps are inspectedĭVSA will check all lamps fitted for correct:Īll side lamps and the rear registration lamp must be operated by one switch, and have a ‘tell-tale’ fitted. This section covers the lamps themselves, refer to section 20 of the IVA inspection manual for angles of visibility.Ībove shows that both front and rear end outline marker lamps may be combined in one lamp. End-outline, position (side), stop and side marker lamps 4.1 How End-outline, position (Side), stop and side marker lamps are inspected See section 18 (statutory plates) of the IVA inspection manual for the full inspection standard. 3.3 The standard statutory plates and VIN must meet There may be other information on the plate but this must be outside of the clearly defined rectangle. maximum laden mass for each axle in order from front to rear.maximum permitted laden mass of vehicle.approval number and/or build stage (if applicable).The only information allowed on the plate must be within a clearly defined rectangle and in the correct order. contain the required information in the correct order.3.2 What to check before statutory plates and VIN are inspected A second stage builder plate - more than the required information is on the plate, but the required information is in a clearly marked separate rectangle.